3D Printables

About

Like a normal piece of straight construction brick track, but half the length...

About

A straight construction brick train compatible track piece with a slot added to hold an MFRC522 RFID reader.

About

This servo mount will allow you to switch a construction brick train turnout using an arduino or other hobbyist microcontrollers with a small servo.

This design has been based around the "SG90 Micro Servo 9g" which is widely avaliable from a wide range of retailers.

Note that there is a 'left' and 'right' version of the base to be used accordingly with left and right hand switches.

About

Stack 3 Gameboy Cartridges, angled at 20 degrees, held by the slot in the bottom of the cartridge with the contacts inside.

About

Display a Gameboy DMG at a 20 degree angle, held and centered by 2 rods going into the screw cavities on the back of the Gameboy.

For an example on placing your Gameboy in the display holder please see the short clip at the end of the slideshow above.

About

Display a Gameboy Pocket at a 20 degree angle, held and centered by 2 rods going into the screw cavities on the back of the Gameboy.

About

Connect narrow gauge construction brick track to old school construction brick track.